Our new ticketing site is now live! Using either this or the original site (both powered by TrainSplit) helps support the running of the forum with every ticket purchase! Find out more and ask any questions/give us feedback in this thread!
Reinstating Platform 4 at Snow Hill
Reinstating Platform 2 & 3 at Kings Norton
Four tracking and electrifying from Cofton jnc (near Longbridge) to Barnt Green
The rail systems and civils designs need doing first - Only an outline design has been produced.
End of 2027 could be a good target date for installation or spring 2028, but that's just me speculating.
There is an ongoing study looking at introducing 4-car Class 350 trains into the bay platform. Moving the platform signal, 3m platform extension and squeezing the minimum stopping allowance.
The bulk of the platform build-out will be to the east of Park Street. It's proposed that there'll be no platform B and A over the New Street approach.
Yes - The platforms on the "Up" side / HS2 side of the station will be "B" and "A"
Platform 5 will be reinstated and a siding will be installed where the OP thought (rightly) a Platform 6 would be too tight.
On whose part? Network Rail has a budget for enhancements and if it is forecast to be an overspend then some projects will be paused. Other projects will be more developed so will be seen out to completion.
1729532724
Tens of new OLE structures have been installed to facilitate the third line...
TOCs like the operational flexibility but Network Rail doesn't like the capital cost and ongoing maintenance liability of an extra pair of points in a tight spot.
One principal aim was to remove the need for the Leeds via Harrogate service to run on the ECML Up & Down lines.
1729156986
Yeah -...
A new deck on new abutments on the Siemens depot side of the road. It's a bit tight!
1729097356
Access will be provided for Platform 8. The P8 link to the York Down Fast line is currently proposed to be removed, but there are a few options for the link to be retained with a new alignment...
Is the two second rule the design standard that says (geometrical) element lengths should be no less than 2 seconds at line speed?
A lot of the national network doesn't achieve that either and over point work it won't apply as you're constrained by S&C geometry.
I've not heard a definitive...
We are aware of an issue with emails from the Forum to Microsoft-based email accounts (hotmail/outlook/live.com email addresses). This is being looked into currently, thanks for your patience meanwhile.