RomeoCharlie71
Established Member
And it is scheduled to be 8, but obviously not enough space at Seagate for themNo—5 buses lay over at the Seagate every night.
And it is scheduled to be 8, but obviously not enough space at Seagate for themNo—5 buses lay over at the Seagate every night.
There must be quite a few empty runs to get the buses back to St Andrews currently, since the duties will be finishing at Dundee. Passed three YY18s not in service between St Andrews and Guardbridge this week.
It’s just the one in use at the moment. 54289 has been in use at Aberhill for a few weeks as a paint float. This will allow all the current Elite’s to be painted.I used the X61 from Ansruther yesterday and was surprised when a new Volvo double deck showed up. It did swapped over for a normal Elite for some reason.
I remember the tri axle Scania Omnilinks on the X55/55 Dunfermline to Edinburgh and as a passenger they were quite nice. I'm sure they were on the X57 Kirkcaldy-Burntisland-Edinburgh and X53 Dalgety Bay-Edinburgh as well. Think they were 07 or 57 plates.Asked about 2 months back but my post got quickly buried so I might as well try again - does anyone have any good sources regarding the origins of Express/Experience City Connect services aside from skimming through route registrations? I’m mainly looking for information about the routes though if anyone would know what happened to all the buses used on ECC routes post-Stagecoach work, that’d also be great.
I remember the tri axle Scania Omnilinks on the X55/55 Dunfermline to Edinburgh and as a passenger they were quite nice. I'm sure they were on the X57 Kirkcaldy-Burntisland-Edinburgh and X53 Dalgety Bay-Edinburgh as well. Think they were 07 or 57 plates.
I am pretty sure the routes have not changed all that much recently, the Glasgow ones I'm sure have been talked about in the forum before, have been mainly the same.
They did try to send coaches from Glasgow to Glenrothes on through Markinch to Leven as an X4 but they struggled to fit through Markinch.
The X26 (similar to current X27) used to pass through Auchtertool on its way from Kirkcaldy to Glasgow.
Edinburgh is roughly the same recently, I remember the former X54 used to be Dundee direct to Ladybank, Glenrothes, Cowdenbeath, into Dunfermline bus station then down to Edinburgh, then it got cut from Dunfermline, then routed via Balmullo, Cupar and Pitlessie, then it got cut from Cowdenbeath, and replaced entirely by X59A and 40.
There have been various changes in the East Neuk but the main routes have stayed the same recently, 97/X58 St Andrews>Largoward>Leven on to Edinburgh and X60 via Elie, now X61
I know quite a few coaches, i.e. SP07 HHO, SP57 AAV, SP06 FVB were bought by Moffat and Williamson and used for school and the odd service work.
I have seen pictures of bendy coaches in Fife however I am not sure if that was pre-ECC.
www.edinburghchamber.co.uk
Yes, so makes you wonder what'll happen with Forfar outstation. You are correct that it is 7 coaches and 16 buses for ArbroathSo the whole Angus fleet will be Electric?
Do Yutong offer an electric double deck coach?Is the 7 coaches going to be deckers?
There was rumours of one in development when I was talking with Yutong and Ember engineering team last year.Do Yutong offer an electric double deck coach?
X7 can also use the chargers at Union Square like the M96 doesIf going to Abroath for the X7, I would imagine that these will be tri axle yutongs and be charged during the layover at Dundee to keep them all day.
7 for a requirement (currently) of 6 might allow some swapping or will we see Dundee based workings also introduced since the recent licence increase for Seagate
If they are triaxle, during the working day the only way to charge them is in the management car park. Not sure if there is room elsewhere on site where they could park instead.X7 can also use the chargers at Union Square like the M96 does
If I had to bet on it, some of the Tayway and Forfar work would move to Dundee then the remainder to work out of Arbroath
Fair point, hadn’t thought of thatIf they are triaxle, during the working day the only way to charge them is in the management car park. Not sure if there is room elsewhere on site where they could park instead.
I’ve heard from 3 Ember drivers at this point that management approached Yutong asking about this & they apparently said that they had no interest in entering the double decker coach market. Obviously doesn’t mean it’s definitely not double decker electric coaches but I wouldn’t get your hopes up about them.Do Yutong offer an electric double deck coach?
Does anyone know is St Andrews bus station has timetable racks?
I noticed this last weekend. The racks are away. The same is the case at Aberdeen Bus Station. I wonder if they have any behind the counters when they are staffed.Does anyone know is St Andrews bus station has timetable racks?
You can find timetables if you ask at Aberdeen at the customer service deskI noticed this last weekend. The racks are away. The same is the case at Aberdeen Bus Station. I wonder if they have any behind the counters when they are staffed.
Dundee still has racks with timetables along with Halbeath.
Dunfermline have took the racks away too.
What do they still print?You can find timetables if you ask at Aberdeen at the customer service desk
last time i was down, it was just normal paper timetables on A4 paper (no route maps or anything) but yes. they had proper X7 and citylink leaflets though, and the 14/Aberdeen Adventurer by mcgills did have too, not sure if they still doWhat do they still print?
Do you reckon if enough pressure was out on stagecoach they would print???Stagecoach North has been handing out paper copies of the online PDF since 2021, but they Stagecoach north Scotland No longer prints timetables. The X7 come from East Scotland but from the Dec 2025 no longer print timetables.
Do you reckon if enough pressure was out on stagecoach they would print???
I feel like anyone who requires paper copies of the timetables, the council office at bus stations and park and rides should all be equipped with a printer & funding to do this.Do you reckon if enough pressure was put on stagecoach they would print???